What gets fixedMicrowave Repairs the Pros Handle
This is the work we route for OTR, wall-mounted, drawer and convection combo microwaves. Every job starts by safely bleeding the capacitor before a single meter lead goes in.
No heatHums but Does Not Heat
The fan spins, the light glows, the plate turns, and the coffee comes out cold. The usual suspects are the magnetron, the high-voltage diode, the capacitor, or the transformer. The technician tests each one with the power off and the capacitor discharged.
- Magnetron filament and insulation tests
- Diode and capacitor checks
- Transformer primary and secondary readings
SparksArcing and Sparks Inside the Cavity
Blue flashes along the side wall usually come from a greasy or burnt waveguide cover, chipped cavity paint, or a damaged rack support on a convection model. Left alone, arcing can pit the cavity and ruin the magnetron.
- Waveguide cover replacement
- Cavity paint and rack support inspection
- Stirrer and antenna check
Door switchesDead Unit or Runs With the Door Open
The door has several interlock switches and a monitor switch that blows the line fuse if the others fail. A totally dead microwave often means that fuse did its job. If yours runs with the door open, unplug it now and do not use it again until it is checked.
- Primary, secondary and monitor switch tests
- Line fuse replacement with root cause found
- Door latch and hinge alignment
ControlsTouchpad, Control Board and Will Not Stop
When keys stop responding or the oven refuses to shut off at zero, the touchpad membrane or a welded relay on the control board is usually behind it. The pro tests the keypad matrix and the relays first so the right part gets ordered.
- Membrane keypad testing
- Control board relay and power supply checks
- Display and clock faults
OTR ventVent Fan, Filters and Light
An over-the-range microwave also works as the range hood. Grinding fans, a lamp that never turns on, greasy metal filters, and a spent charcoal filter on recirculating installs all get handled here.
- Vent fan motor and damper
- Grease and charcoal filter replacement
- Cooktop light and lamp socket
MountingTurntable, Mounting Plate and Wall Bracket
A plate that will not spin usually needs a turntable motor or a new coupler. OTR units that sag or rattle may have a loose wall bracket or top bolts pulled through the cabinet, which is a safety issue with a hot stove below.
- Turntable motor and coupler
- Mounting plate re-anchoring into studs
- Top cabinet bolt repair